Step one: grab your 130$ baur trade bag and sit uncomfterably down near the outlet youll be fucking with.
Step two: grab your 30$ mutil use driver from milwakee and unscrew the recepticle cover and recepticle but be sure the wait for 30 minutes as your helper keeps flipping breackers just for your helper to kill off the whole house.
Step three: snip off the wires from the recipticle and if its in back stab then get your self a new recipticle with side screws. Then use your fingers the remove the junction box becuase the previous people just use a tar like glue to hold the junction box on the concreate wall of the poor old ladies house your working on.
Step four: punch holes in the new junction box to allow wires to pass through and use your 130$ impact driver with 40$ bit kit to enlarge the back holes of the junction box so it can take a SDS plus bit.
Step five: dry fit the new junction box in and use your 400$ rotary hammer to hammer drill holes into the concreate wall but be carefull as the hammer drill is way more powerfull then chads muscles. Use electric tape to prevent over drilling. Then use your impact driver to drive in concreate screws in so the junction box stays in for good.
Step six : snip,strip and install new wire into the new recepticle and be sure the exposed copper is going in clock-wise to ensure proper tight fitting. Then use electric tape to cover the exposed screws/ copper from over stipped wire to prevent house fires.
Step seven: use your 15$ plug tester after turning power back on to ensure proper wiring. Then use your 400$ fluke T6-1000 pro to measure voltage to ensure no fuckery going on.
Step eight: fuck off out of the house.
See? Itsnt repacing a junction box easy? Easy 100$!!!!! I can do it! So easy! Just get gud bro! Just blow money in expensive tools bro! Just bend your back in uncomfortable positions bro! Just wear out your wrists bro!
Step two: grab your 30$ mutil use driver from milwakee and unscrew the recepticle cover and recepticle but be sure the wait for 30 minutes as your helper keeps flipping breackers just for your helper to kill off the whole house.
Step three: snip off the wires from the recipticle and if its in back stab then get your self a new recipticle with side screws. Then use your fingers the remove the junction box becuase the previous people just use a tar like glue to hold the junction box on the concreate wall of the poor old ladies house your working on.
Step four: punch holes in the new junction box to allow wires to pass through and use your 130$ impact driver with 40$ bit kit to enlarge the back holes of the junction box so it can take a SDS plus bit.
Step five: dry fit the new junction box in and use your 400$ rotary hammer to hammer drill holes into the concreate wall but be carefull as the hammer drill is way more powerfull then chads muscles. Use electric tape to prevent over drilling. Then use your impact driver to drive in concreate screws in so the junction box stays in for good.
Step six : snip,strip and install new wire into the new recepticle and be sure the exposed copper is going in clock-wise to ensure proper tight fitting. Then use electric tape to cover the exposed screws/ copper from over stipped wire to prevent house fires.
Step seven: use your 15$ plug tester after turning power back on to ensure proper wiring. Then use your 400$ fluke T6-1000 pro to measure voltage to ensure no fuckery going on.
Step eight: fuck off out of the house.
See? Itsnt repacing a junction box easy? Easy 100$!!!!! I can do it! So easy! Just get gud bro! Just blow money in expensive tools bro! Just bend your back in uncomfortable positions bro! Just wear out your wrists bro!
